IC Send Software

Resources | Manual | Download

IC Send is a Windows application for testing iC-Net communication and control. Setup just takes a few steps:

For RS-232 control, connect a Female to Female null model cable (TX and RX swapped at one end) between a PC and a CR iC-Net Head End. Connect the cable to the Program Port, not the iC-Net port.

Check to make sure the DIP switches on the from of the Head End is set to 19.2 Kb.
Switch 6 set to Off, Switches 7 and 8 On.
Launch iC Send – no installation is needed.
For IP Port, enter the IP address of the Head End.
Click FIND to connect to the IC Head End, then IC Send will display “Seeking Device”.
If IC-Send connects to the Head End, the firmware version of the HE will appear at the top left below the menus.
If you change the cable or DIP switch settings on the HE, click FIND to re-connect.

Entering Commands

Command: Enter the command code in the first field. (See chart in IC Send manual)
Parameter: Enter the parameter, if needed, in the second
Device: Enter the device or Zone number for the controller(s)
Click SEND to send the command.

Terminal
There is a pop-up Terminal window in development, will be fully functional in a future update.