[

ICC-P Philips Smart Display Controller

]

Specifications

Physical

Size: 5.47" [139mm] wide x 6.35" [161mm] height x 1.13" [29mm] deep
Weight: 12 oz [341g]
Enclosure: All aluminum with durable black powder coat paint
Mounting: Mounts on rear of display

Front Panel Status

Net LED: Green LED for iC-Net bus, flashes once per second if receiving communication
TV/COM LED: Yellow LED, flashes when receiving IR data, stays off when Smart data not active
Error LED: Red LED indicates a problem within the unit

Connections

RF Out: Internal RCA female, 75 ohm impedance, RF to TV
Ant/Cable: 'F', female, 75 ohm impedance, RF from CATV system
iCC-Net: Carried over the same RF coax connection as TV channels
  Receive: Mid-band VHF, 74.7MHz, sent from IC Head-End Network Controller
  -25 to +35 dBmV signal level
  Transmit: Sub-band, 5.6MHz sent to Head-End Network Controller
  +/- 80 KHz max carrier deviation, +49dBmV nominal (ICC2 models only)
To TV: RJ-12 female 6-pin Telco jack, accepts included Smart TV data cable
Power In: 2.1mm coaxial jack (inside center conductor positive), 100 mA maximum 9 to 16.5 VDC, 12 VDC typical (may be unregulated)

Includes

Smart TV data link cable
Mounting hardware
RF Loop Cable
12 VDC Power Supply, 100 mA (Not included for international shipments or if powered by TV)
IC-RC Wireless IR Remote required for setup and user control, available separately

Options

IC-RC Wireless IR Remote for user control and system setup
Internal buzzer used for system-activated alerts