ICC1-IR TV Controller

Specifications

Physical

Size: 5.5" [140mm] wide x 1.1" [28mm] high x 3.4" [86mm] deep
Weight: 8 oz [226g]
Enclosure: All aluminum with durable black powder coat paint
Mounting: Mounts rear of TV

Front Panel

RF In: 'F', female, 75 ohm impedance, RF from CATV system, iCC-Net control
RF Out: ‘F', female, 75 ohm impedance, RF to TV
Low-loss internal tap - less than -1.5 dbmV loss
Net LED: Green LED for iC-Net bus and DC power, flashes once per second if active
IR Out: 3.5mm jack for CC-IRE IR Emitter cable or compatible CC-IRS serial cable
Supports carrier frequencies up to 62 KHz
IR Out LED: Red LED lights when sending IR commands
Power Sensor: 3.5mm jack for included CC-HSD scan sensor or 5V logic-level input
Power Sensor LED: Red LED lights when sensor indicates power on
Power In: 2.1mm coaxial jack (inside center conductor positive), 75 mA maximum
11.5 to 16.5 VDC, 12 VDC typical (may be unregulated)
DIP Switches: Located on bottom of unit, sets IR code operation and device number

ICC-Net

Operation: 1-way control, carried over the same RF coax connection as TV channels
Data Receive: Mid-band VHF, 74.7MHz, sent from IC Head-End Network Controller , -25 to +35 dBmV signal level

CC-HSD Scan Sensor

Range: Senses presence of TV scanning, from 15-35 KHz, magnetic pick-up
Includes: 3.5mm plug, 4ft. cable, stick-on TV sensor

Includes

Space-saving 12 VDC 500 mA digital switching power supply (North American shipments only
CC-HSD Scan Sensor (if required)
CC-IRE IR Emitter
RF Loop cable
Mounting Velcro for unit

© 2008 Contemporary Research Corporation. All rights reserved.